How to apply Pre Bonded Hair Extensions & Micro Loop Ring Hair Extensions?

Author: Jacky Keeran

Pre Bonded Hair:

1. Put pre bonded hair extensions, hair extension heating iron, Fine tooth Comb and some clips in place. Switch on your heating tool.
2. Divide the hair into some small sections. Use a comb to make one section of hair on top of the head to horseshoe shape, encompassing all the hair in the bangs and crown area. Using clips to Twist the hair and clip it out. Then, pin sideburns in front of the ears.
3. Around the nape of the neck, make a clear hairline by leaving a 1.5cm section of loose hair. Above this loose hair, divide the rest hair into some rows of hair on which you would like to apply your pre bonded hair extension.
4. Select strands of hair in sections that are roughly equal to half the size of the glue tip. Position it underneath the hair you have, about 1 cm below the scalp. Put the groove of the extension bond into the groove of the extension fusion iron. Close the iron and hold for a few seconds to melt the glue into your hair strands.
5. Remove the heating iron and gently roll the fused glue tip around the hair strand to make a cylinder as it become cool.
6. Repeat the application down the row by selecting sections of hair strands. Make the extensions around 1 inch apart from one another.
7. Complete, unclip the next row of hair and continue adding the extensions to the hair by repeating above steps, until all rows are completed.
8. Now, enjoy your lovely pre bonded hair extension and new looking. For more information, please make a consultation with your hairdresser.

Micro Loop Ring Hair Extension.

1. Use a comb to separate the hair into four workable sections: two in the front and two in the back. Hold your remaining hair up with clips.
2. Separate your hair across the back into very small sections ensuring you make a clean straight line. Starting with one of the back sections, Pick up a small section of your own hair (about the same volume as one strand of Micro Loop Ring Hair Extensions) and twist it to make it easy to handle. Take one strand of Micro Loop Hair Extensions and slide your own hair through the white plastic loop.
3. Making sure to work closely to the scalp, pull the plastic loop tab from the bottom and keep pulling until your own hair is threaded through the micro bead. The white loop should now be completely free from the micro bead.
4. Move the extension strand towards your scalp, but do not make it too close and please leave enough to give a little free swing. Put the extension hair downward and take a pair of pliers to flatten the micro bead firmly. Make sure the bead lies flat against your head.
5. Repeat above Steps on the remaining sections of your own hair until all of the extensions have been applied. To make the hair look completely natural and cover up the micro rings, remember leave a small section in the front undone. You will have enough your own hair left around the hair line to cover the micro beads if you wish to wear your hair up.
6. When you're finished, curl or style the hair as desired. Enjoy your lovely Micro Ring Hair Extensions.

Article Source: http://www.articlesbase.com/hair-articles/how-to-apply-pre-bonded-hair-extensions-micro-loop-ring-hair-extensions-5655833.html

About the Author

http://www.hair100.co.uk/pre-bonded-hair-extensions.html

http://www.hair100.co.uk/shop/10/index.htm

http://www.hair100.co.uk/shop/15/index.htm